What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 02:13

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
If women aren't shallow, why do most tall, good-looking men have girlfriends?
One is “what exactly is in a ‘surge protector’ ? ”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
These are simplified answers to the original question, and does not change anything I wrote above.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
But it can get overloaded, and no longer works.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
nine
New Research Reveals the Brain Learns Differently Than We Thought - SciTechDaily
I post the exact comment here.
There are two important concepts here.
This is where the MOV conducts again, and dissipated the energy.
What species of fish are horse mackerels?
A circuit breaker is similar, but is resettable.
For this case there are devices called Metal oxide varistors (MOV).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Microsoft belatedly attempts to tame USB-C confusion with its rules for PC OEMs - Ars Technica
The other is “what does a “fuse” do?”
He then describes Rainy Season and Lightning.
This device then solves the entire problem.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
An AC voltage/ current source, and an ac inductive load.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Do you like Melania Trump's new official 1st lady black & white power portrait?
This one hit behind the barn.
2024–10–14 [Omar Gharbi Omar Gharbi ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
Snakes in the yard … maybe more in the future - ironmountaindailynews.com
Barnstars:
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
eight
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then asserts :
Edit 2024–10.
The bolt then partially travels down the line to your home.
But… the neutral is now “floating” because of the 1 ohm resistance.
The MOV will conduct when the voltage exceeds 50% of line voltage.
what exactly is a ‘surge’ protector?
Here is a simplified AC power diagram.
It also is a device that limits the change in current flow.
Now when you have a certain ac resistance, then a current flows in a loop.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are three different concepts here that are getting confused.
Upvotes:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What is lightning?
He then describes the function of a fuse.
A fuse is a non-resetable over current circuit protector.
These devices are installed between the “hot” and “neutral” and protective ground.
First Sentence:
but this device (an Inductor) … impedes the rapid changes in the current.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
so, what happens?
the problem then depends on "how fast does the fuse operate?".
[image of Common-mode choke]
a photo is worth a thousand words.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What does a fuse do?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At one ohm, the resistor has a maximum of 1 watt power.
(Dc diagram shown, AC is similar).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
[old diagram got deleted by accident]
One
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–10[John johnson John Johnson ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Because the load is inductive, the current lags the voltage.(by a bit).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
but I think this circuit , shows a few more pieces.
This is 'the assistant's answer'
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
At least they know the answer if they wanted it.
The third is lightning and “how it gets conducted into a home.”